Work process: drawing of cornices
Step by step from template to finished profile
Pulling requires preparation and a steady hand. Follow the steps here so you get an even, filled profile.
§Preparation
- 01Make the form carefully according to the model
- 02Put up battens that the template can run along
- 03Check that substrate is clean and provides good adhesion
§The actual pulling
- 01Mix only the amount of material you can use in time
- 02Apply mass in several batches, not all at once
- 03Before the template evenly along the batten for each round
- 04Fill up until the profile is completely filled
§Conclusion
- 01Check profile full length for unevenness
- 02Correct small mistakes with template or scraper while the mass is fresh
- 03Clean template and tool immediately